3/4" Red and Lime Reflective DOTS for Diamond Plate
3/4 Inch Red and Fluorescent Lime Dots for Diamond Plate
On this page we offer 3/4" - 100 dot packs of Retro Reflective Circles in fluorescent lime and red for diamond plate. The dots are used to create chevron stripes on diamond plate so that it is compliant with NFPA 1901 specifications for emergency vehicles.
We use Reflexite V98 Prismatic Daybright material which is the industry standard for prismatic reflective sheeting. Reflexite invented prismatic sheeting and continues to be the industry leader.
We sell these in lots of 100 dots on a sheet. For example, to order 1000 dots you would enter 10 in the quantity box below. Each sheet of 100 dots is $10.
To install our reflective dots or circles you simply peel and stick to a clean, dry surface. You can use them in quantity to create stripes, letters, numbers, etc.. You can also use them to increase visibility on doors and sliding trays. Emergency vehicles use these dots in a variety of areas for night time visibility. The 3/4" dots are especially useful in creating chevron stripes on diamond tread plate. Dots are easier to line up than squares and tend to stay down better due to there being no sharp edges.
(Coverage Rate for 3/4" dots on Diamond Plate - 1 dot to the square inch or 144 dots to the square foot.)
3/4" Dots in Red or Fluorescent Lime (sheets of 100) - $10
To read our article on how to estimate the number of shapes you will need for your diamond plate click here.
Choose your color and then in the quanity box put the number of 100 dot sheets you need. (example - 5 sheets equals 500 dots)